Advertisement
ITEM
DESCRIPTION
4
Q.S. D4 S/S Worksurface
5
Q.S. D4Hat Section
HARDWARE KIT QS-HWR214
ITEM
DESCRIPTION
B
Washer 1/4 Flat Black
D
Bolt 1/4-20 Hex Head Black
Step 6:
Lay the worksurface upside down on a clean padded surface. Position the worksurface hat
sections over the threaded inserts in the front and middle portion of the worksurface and center
them left to right of the worksurface. Attach each hat section with 8 sets of Item # D and B.
Tighten hardware only when all bolts are started by hand. Do not tighten this hardware to more
than 10 foot lbs of torque. Do not over tighten. If this is an ESD worksurface attach the ESD
Coupler Nut found in hardware kit QSHWR014. See page 32 for installation caution notes.
Note:
If your order includes 6" or 12" single drawers units you can assemble the drawer cases onto the
worksurface hat sections at this time. This makes the attachment of the drawer cases easier but
also makes the worksurfaces heavier and therefore more difficult to turn over and place into
position. Caution must be taken during this process to insure that assemblers are not injured
during and that the worksurfaces and the surrounding areas are not damaged. If you choose to
assembly the drawer cases to the worksurface at this time IAC Industries recommends that all
assemblers are wearing proper safety equipment. Refer to page 18 for drawer assembly
instructions.
QTY
1
2
QTY
16
16
6
Advertisement
