Advertisement
HARDWARE KIT QS-HWR214
ITEM
DESCRIPTION
D
Bolt 1/4-20 Hex Head Black
B
Washer 1/4 Flat Black
Note: If your order includes accessories such as shelves, light fixtures, parts cup stringers, flipper
door cabinets, footrests and electrical channels IAC Industries recommends that they be
assembled to the uprights before you install the worksurfaces. This reduces the reach distances
for installing these items making assembly much easier and safer.
Step: 7
Turn the worksurface sub assembly over and carefully place the rear of the worksurface onto the
top support brackets. Align the side cutouts of the worksurface between the uprights and gently
slide it into position. There should be approximately a 1/16" gap between the front of the upright
and the cutout in the worksurface, and approximately a 1/8" gap between the side of the uprights
and the side of the cutouts.
Step: 8
Align the threaded inserts in the bottom of the worksurface with the slots in the back panel and top
support brackets. Install 4 each item # D and B into the slots in the back panel, and 2 each item #
D and B in the slots in each top support brackets by hand. When all hardware is installed and the
worksurface is aligned, squared and leveled with the uprights, tighten all worksurface hardware.
Do not over tighten.
Note: If you are assembling starters and adders it is best not to tighten any of the worksurface
attachment hardware until all the worksurfaces are installed. Then align, square and level all the
worksurfaces and tighten attachment hardware. Do not over tighten.
Please read Caution and Warning Notices found on page 2.
QTY
8
8
7
Advertisement
