Advertisement
Quick Ship D4 Single Sided Workstation Starter & Adder
ITEM
DESCRIPTION
1
Q.S. D4 Back Panel
2
Q.S. D4 Top Support Bracket LT
3
Q.S. D4 Top Support Bracket RT
HARDWARE KIT QS-HWR214
ITEM
DESCRIPTION
A
Bolt 5/16-18 x .75 SQH
B
Washer 5/16 Flat
C
Nut 5/16-18 Hex Keps
Please read Caution and Warning Notices found on page 2.
Step 1:
Install 5/16-18 x .75 square head bolts item A, 5/16 flat washer item B, and 5/16-18 hex head
keps nuts item C into each end of all back panels item 1 and into all top support brackets items 2
and 3 as shown below. Do not tighten this hardware.
Step 2:
Make small pencil marks on the uprights approximately 1 1/4" lower than the desired working
height. It is a good idea to make these marks all the uprights at the same time. Install the back
panel and top support bracket by leaning an upright against a wall or have a second person hold it
and install the square head bolts into the milled slots in the nut channels of the upright. Gently
slide the back panel and top support brackets to the pencil marks and tighten the hex head keps
nuts to hold them in place. Do not tighten this hardware to more than 10 foot lbs of torque. Doing
so will cause scoring to the aluminum of the upright.
QTY
1
1
1
QTY
8
8
8
4
Advertisement
