Sharp DX-B351PL User Manual page 5

22. This is a low-voltage device. When using the device below its specified voltage, if the toner comes off the
printed contents, or the equipment starts up slowly, please refer to the product precautions or call
SHARP Service Center.
23. This product is sold as a complete machine. The consumers can go to SHARP Service Center to
purchase parts they need. If the product sold is inconsistent with the package list, please go to the
specified Service Center to solve the problem.
24. Install this product in a place where the temperature is between 50 and 90° F and the relative humidity
between 20% and 80%.
25. This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS
standard(s). The operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause
undesired operation.
26. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
27. Changes or modification not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
28. Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
29. This Class B digital apparatus complies with Canadian ICES-013.
30. Please store this User Guide properly.
IV