Table of Contents
Advertisement
• Using a grounding wire with ball & socket termination
Unscrew knob (2) from the grounding socket
(1).
Screw the grounding pin (15) tightly into the
socket (1) (1/2"-13 UNC thread).
Fully unwind the grounding wire and connect
it by the clamps to the grounding pin (15) and
to the grounding system using the clamps.
3.4) Positioning the cutting head
The cutting head must be manually positioned
around the cable to be cut based on the diameter
of the cable (Ref. to § 1).
TC065Y-SC-KV and TC096Y-KV: insert the cable
between the blades, at the desired cutting point.
TC050Y-KV and TC085Y-KV: release latch (5) to open the blades.
Insert the cable, close the head and fully secure the latch (5).
Ensure that the head is fully secured: partial closure may damage the head.
TC120Y-KV: Extract the locking pin (13) to open the blades. Insert the cable, close the head and
fully secure the locking pin (13).
Ensure that the head is fully secured: partial closure may damage the head.
Make sure the blades are exactly positioned on the desired cutting point.
TC050Y-KV
5
Once the blades of the cutting head are around the cable to be cut, stabilise the head in position
(e.g. by pressing the cutting head against the ground); when used in the "man-hole" we recommend
the usage of SS-TCY support strap (Ref. to § 6) in order to support the head in the horizotal stable
position.
7
5
cable
TC085Y-KV
1
15 *
2
TC120Y-KV
13
cable
Advertisement
Table of Contents
