Dynojet POWER COMMANDER V Installation Instructions page 4

FIG.D
Unplug
FIG.E
PCV
FIG.F
I19-035
STK
PCV
www.powercommander.com
7 Locate and unplug the stock wiring harness from the Fuel Injector (Fig. D).
The Fuel Injector is located at the top of the intake plenum just beneath the
fuel rail at the rear of the cylinder head.
8 Plug the pair of PCV wiring harness leads with ORANGE colored wires in-line
of the Fuel Injector and the stock wiring harness (Fig. E).
9 Locate the stock BLACK 6-pin Throttle Body Servo connector on the Throttle
Body Servo just rear of the Fuel Injector.
10 Use the supplied Posi-tap to attach the single unterminated GREY wire of the
PCV wiring harness to the stock GREEN/RED wire (pin position #1) of the
stock Throttle Body Servo connector (Fig. F).
11 Continue routing the harness towards the right side of the engine.
2015-2018 Polaris Ranger 570 - PCV F/I - 4