Figure 6-7 Backshell Assembly (Configuration Module With Spacer); Table 6-4 Configuration Module Kit P/N 011-00979-00 (P1001) - Garmin GTN Xi Series Maintenance Manual

Table 6-4 Configuration Module Kit P/N 011-00979-00 (P1001)

Figure 6-7
Reference
1 Configuration Module, PCB Board Assembly w/EEPROM
2 Spacer, Configuration Module
3 4-Conductor Harness
4 Pin Contact, Crimp, #22D

Figure 6-7 Backshell Assembly (Configuration Module with Spacer)

Removal
1. Disconnect the connector from the GTN Xi backplate assembly.
2. Remove two screws (5) from cover (6) and remove cover.
3. Unplug the connector from the configuration module (1).
4. Remove the configuration module from the backshell (7).
Re-installation
1. Inspect the connector for damaged pins (4) or wires (3).
2. Apply spacer (2) by wrapping it around the PCB board (1) making sure to insert the plastic
connector mounted on the board into the hole provided in the spacer.
3. Place the configuration module (1) in position.
4. Insert connector into the configuration module (1).
5. Place the cover (6) back on the connector and re-install screws (5).
190-01007-C1
Rev. 1
Description
5
x2
1
2
4
6
3
GTN Xi Part 23 AML STC Maintenance Manual
Garmin P/N
012-00605-00
213-00043-00
325-00122-00
336-00021-00
7
Page 6-14