Backshell Assembly - Garmin GMA 35 Installation Manual

Manufacturer Hand
(Note 1) Crimping Tool
Military P/N M22520/2-01
Positronic 9507
AMP 601966-1
Daniels AFM8
Astro 615717
1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject to
change without notice.
2. Extracting the #18 and #20 contacts requires that the expanded wire barrel be cut off from the
contact. It may also be necessary to push the pin out from the face of the connector when using an
extractor due to the absence of the wire. A new contact must be used when reassembling the
connector.

3.5 Backshell Assembly

The GMA 35 connector kit includes two Garmin backshell assemblies. Garmin's backshell connectors
give the installer the ability to quickly and easily terminate shield grounds at the backshell housing using
the Shield Block. To assemble the backshell connectors and grounding system, refer to instructions
provided in the Shield Block Installation Instructions (190-00313-09).
190-00858-11
Rev. H
Table 3-2. Recommended Crimp Tools
18-20 AWG
Positioner
N/A
9502-11
N/A
K774
N/A
NOTES
Insertion/
Extraction Tool Positioner
(Note 2)
M81969/1-04 M22520/2-09
M81969/1-04 9502-3
91067-1 601966-6
M81969/1-04 K42
M81969/1-04 615725
GMA 35/35c Installation Manual
22-28 AWG
Insertion/
Extraction
Tool
M81969/1-04
M81969/1-04
91067-1
M81969/1-04
M81969/1-04
Page 3-2