6 EQUIPMENT REMOVAL AND RE-INSTALLATION
6.1
GTN Xi .............................................................................................................................................6-2
6.1.1
Display of Self-Test Data...........................................................................................................6-5
6.2
GMA 35 ............................................................................................................................................6-6
6.3
Data Card/Flight Stream 510 ............................................................................................................6-9
6.4
Flight Stream 210............................................................................................................................6-10
6.5
NAV Antenna Cable Diplexer........................................................................................................6-11
6.6
NAV Antenna Cable Splitter ..........................................................................................................6-11
6.7
6.8
GTN Xi Fan ....................................................................................................................................6-15
6.9
6.9.1
Fuse ..........................................................................................................................................6-18
6.9.2
TVS ..........................................................................................................................................6-18
This section describes how to remove and replace equipment associated with this STC. After removal and
re-installation, LRUs must be configured and tested as described in Section 7.
CAUTION
When removing and/or replacing a GTN Xi, GMA 35, or any other item under the scope of
the STC installation, always ensure that the aircraft power is off. Unplug any auxiliary
power supply.
190-01007-C1
Rev. 1
GTN Xi Part 23 AML STC Maintenance Manual
Page 6-1