Table 7-1 Configuration And Checkout Procedures - Garmin GTN Xi Series Maintenance Manual

7.1 GTN Xi
Original GTN Xi Re-installed
If the removed GTN Xi is installed in its original position, no software loading or configuration setting
changes are required. This does not include units that were returned for repair, as their software and
configuration files are deleted during the repair testing progress. It is recommended to perform the
Connector Engagement Check (refer to Section 7.1.2.1) to ensure proper seating of the connectors.
New, Repaired, or Exchanged GTN Xi Installed
If a new, repaired, or exchanged GTN Xi is installed, the correct software must be loaded to the unit. Some
configuration files must be set. Refer to the summary in Table 7-1. Any enabled features, such as TAWS B
or ChartView, will not need to be re-enabled if the configuration module was not replaced.
This section covers the necessary steps to configure and test a replacement GTN Xi. The steps provided in
this section are only applicable for replacement of an equivalent GTN Xi (e.g., 750 for 750). If wiring
updates are needed, or the configuration module is being replaced simultaneously, refer to GTN Xi Part 23
AML STC Installation Manual for installation and configuration instructions.

Table 7-1 Configuration and Checkout Procedures

Modification
Replacing GTN 6XX/
7XX with equivalent
GTN Xi unit
Replacing GTN Xi
with equivalent
GTN Xi unit
Replacing
configuration
module with new
module
Replacing
navigation indicator
190-01007-C1
Rev. 1
Required Action
Refer to GTN Xi Part 23 AML STC Installation Manual for
instructions on replacing GTN 6XX/7XX unit with
equivalent GTN Xi unit.
Repeat configuration steps described in
Section 7.1.1.1 (COM Configuration).
Repeat configuration steps described in Section 7.3.1.1.2
(VOR/LOC/GS Configuration) and Section 7.3.2.1 (Serial
Tuned DME Configuration).
Perform ground checks per Section 7.1.2 (GTN Xi Ground
Checks), Section 7.3.1.2.2 (VOR/ILS/GS Indicator) and
Section 7.3.2.2 (Interface Check).
Ensure that the GTN Xi software is the version specified
on Equipment List GTN Xi Part 23 AML STC (P/N 005-
00533-L1). Ensure that the Basemap, Navigation,
SafeTaxi, and Obstacle databases are up-to-date per
Section 3.3 and insert SD card from previous GTN 6XX/
7XX into the replacement unit.
Database cards need to be recreated when updating the
configuration module. Refer to Section 3.3 for instructions
regarding database updates.
Feature enablements must be reactivated. A new feature
enablement card is required. Contact Garmin for a new
feature enablement card.
Repeat calibration per section Section 7.3.1.1.1.1 (OBS
Resolver Calibration) (if using GPS) or Section 7.3.1.1.2.1
(Calibrate Resolver) if using VOR/LOC/GS receiver.
GTN Xi Part 23 AML STC Maintenance Manual
Affected Models
GTN Xi
GTN Xi
GTN Xi
GTN Xi
Page 7-2