Exiting Mission Critical Geofence; Trunking System Controls; Operating In Failsoft System; Out-Of-Range Radio - Motorola APX 1000 User Manual

MN000255A01-BL
Chapter 2: Advanced Features
NOTICE:
Depending on how your radio is programmed, you may or may not be alerted by Voice
Announcement (VA), TMS display, Intelligent Backlight, and the Transmit Power Level. The
user will be alerted only if these indicators are configured in the radio. The VA can be
programmed to alert continuously or momentarily.
If Site Selectable Alert (SSA) is enabled, the radio mutes any alert that is received when
entering the Geofence area and unmutes when exiting.
2.14.4

Exiting Mission Critical Geofence

When and where to use:
When the radio exits the Geofence area, the radio reverts to the original transmit power level,
intelligent lighting, channel or newly assigned talkgroup. Voice announcement is cancelled or the user
hears a pre-programmed VA tone. The radio displays the new channel and a message is received to
indicate the changes.
2.15

Trunking System Controls

This chapters explains the trunking system control features in your radio.
2.15.1

Operating in Failsoft System

When and where to use:
The failsoft system ensures continuous radio communication during a trunked system failure. If a
trunking system fails completely, the radio goes into failsoft operation and automatically switches to its
failsoft channel.
During failsoft operation, your radio transmits and receives in conventional operation on a
predetermined frequency. You hear a medium-pitched tone and the display shows Failsoft.
When the trunking system returns to normal operation, your radio automatically leaves failsoft
operation and returns to trunked operation.
To continue in Failsoft and to communicate with other talkgroups, refer to the following procedure.
Procedure:
1 Rotate the 16–Position Select Knob to change to a different repeater frequency.
2 Press the PTT button to talk, and release the button to listen.
2.15.2

Out-of-Range Radio

When your radio goes out of the range of the system, it can no longer lock onto a control channel.
You hear a low-pitched tone and/or the display shows the currently selected zone/channel combination
and Out of range. Your radio remains in this out-of-range condition until it locks onto a control
channel or failsoft channel, or if it is turned off.
2.15.3

Site Trunking Feature

If the zone controller loses communication with any site, that site reverts to site trunking. When this
occurs, you can communicate only with the radios within your trunking site.
104