Using The Speed Dial Memory; Changing The Digital Security Code; Dialing A Stored Number; Chain Dialing - Uniden 4541 Owner's Manual

Using the Speed Dial Memory

Storing Numbers in Speed Dial Memory
Your cordless phone can store up to ten numbers (up to 20 digits each) in the speed dial
memory. To store number in memory:
1) When the phone is in standby, press [memory]. The talk/batt low LED flashes.
2) Use the keypad to enter the phone number.
(To enter a 2-second pause between numbers, press [redial/
pause]. Each pause counts as a digit. )
3) Press [memory] again.
4) Select the speed dial location where you would like to store the
number ( [0] to [9] ). You will hear a confirmation tone indicating
that the number has been stored.
NOTE:
• Storing a number to a speed dial location will
overwrite the any previously stored number without
warning.
• When storing numbers into memory and the handset is idle (i.e., no key is
pressed) for more than 0 seconds, it will beep rapidly, and then the phone
will return to standby.

Dialing a Stored Number

1) When the phone is in standby, press [talk], and listen for a dial tone.
2) Press [memory] and enter the speed dial entry ([0] – [9]) that has the stored number
you want to dial. (If you enter a digit that does not contain a stored number, the
handset will beep rapidly, and the phone will not dial.)

Chain Dialing

The speed dial memory is not limited to phone numbers. You can store any number (up
to 20 digits) that you need to enter once your call connects. This is referred to as Chain
Dialing. An example is a frequently refilled prescription number. Store your pharmacy
phone number in one speed dial and your most frequently refilled prescription number
as another speed dial. To use, once you ring your pharmacy's automated prescription
line, simply press [memory] and the speed dial number where you stored your account
number.

Erasing a Stored Number from Memory

1) With the phone in standby, press [memory] twice.
2) Press the number of the speed dial entry. A tone indicates that the stored number is
erased from memory.

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the
base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set. In the rare
situation that you suspect another cordless telephone is using the same security code,
you can change the code.
1) Pick up the handset from the base unit. Press and hold [find] on the base.
2) While holding [find], place the handset in the base unit. Leave the handset in the
base for more than three seconds. A new random security code is set.
NOTE: If the handset battery pack is completely discharged or the battery
pack is removed, the digital security code will be lost. If this happens, a new
security code is set automatically next time the battery pack is charged.
Operational Frequency
Frequency 924.516925 – 926.704425 MHz
2,405.155942 – 2,411.718441 MHz
7