Table of Contents
Advertisement
23. When the heat exchanger is latched, make sure that there is a tight fit between
the heat exchanger and the rack frame. Loosen or tighten the latch adjustment
screw as required.
24. Install the upper air baffle on the rack:
a. Climb the platform ladder and loosen the two screws that secure the rear
cable-access cover and remove the cover.
Screws
Sliders
Figure 26. Removing the rear cable-access cover and installing the upper air baffle
b. Secure the air baffle to the rack with three M6 screws.
Upper
air baffle
Rear cable
access cover
Chapter 4. Installing the heat exchanger
39
Advertisement
Table of Contents
