Filling The Heat Exchanger With Water - IBM Rear Door Heat eXchanger V2 Installation And Maintenance Manual

Filling the heat exchanger with water

To fill the heat exchanger with water, complete the following steps.
Statement 14:
CAUTION:
Goggles are needed for the procedure.
(L011)
Attention:
purge air or nitrogen from the heat exchanger.
Figure 37. Removing the inner hose access panel
48
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
Wear safety goggles or other eye protection whenever you fill, drain, or
1. Remove the inner hose access panel from the inside of the heat exchanger.
Inner hose
access panel