Replacing The Latch On The Heat Exchanger - IBM Rear Door Heat eXchanger V2 Installation And Maintenance Manual

Replacing the latch on the heat exchanger

To replace the latch on the heat exchanger, complete the following steps:
1. Unlock and open the heat exchanger.
2. On the inside of the heat exchanger, use a Phillips screwdriver to loosen the
3. Align the replacement latch with the hole on the outside of the door and from
Figure 62. Removing and installing the heat exchanger latch
4. When the heat exchanger is closed and latched, make sure that there is a tight
76
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
latch mounting bracket and remove the bracket and the latch.
the inside, secure the mounting bracket and the latch to the heat exchanger
with the screw.
M5 screw
fit between the heat exchanger and the rack frame. Loosen or tighten the latch
adjustment screw as required.
Adjustment
screw
Door latch
Mounting
bracket