IBM Rear Door Heat eXchanger V2 Installation And Maintenance Manual page 44

11. Partially install the top hinge bracket:
Figure 21. Partially installing the top hinge bracket
34
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
a. Locate the top hinge bracket.
b. Align the top hinge bracket with the three holes in the top right side of the
rack.
c. Use a Phillips screwdriver to partially insert a screw in the hole that is the
farthest away from the rear of the rack. See the illustration. Do not fully
tighten the screw at this time.
d. Rotate the hinge bracket to the left or right so that it is temporarily out of
the way.
Screw
Top hinge
bracket