Installing The Heat Exchanger - IBM Rear Door Heat eXchanger V2 Installation And Maintenance Manual

Installing the heat exchanger

Attention:
1. Because of the size and weight of the heat exchanger, three trained persons
2. You must remove the power from the rack and all components before you
To install the heat exchanger on a Type 9363 rack, complete the following steps:
Figure 16. Lowering the leveling pads
30
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
are required to install or remove the heat exchanger.
connect or disconnect the water supply lines and drain or fill the heat
exchanger.
1. Read the safety information that begins on page iii and "Installation guidelines"
on page 29.
2. Use the wrench that comes with the rack to lower the front and rear leveling
pads. Make sure that the rack is level to the floor.
Leveling pad
3. Remove the rack rear door. For more information, see the IBM 42U 1100 mm
Deep Dynamic Rack and Deep Dynamic Expansion Rack, Type 9363
Installation Guide on the IBM Documentation CD that comes with the rack.
4. Remove power from the rack and all installed components.
Leveling pad
Rear swivel caster
Front fixed caster