Lipo, Lilon, Life, Nicd, Nimh Battery Discharge Processes; Discharge Mode Per Battery Type - GRAUPNER POLARON AC/DC SPORTS Operating Instructions Manual

The programmed data are stored to memory to be used in the battery discharge process.
Tapping the Enter button causes the charger to initiate the preliminary steps, including
a check of the balance connector, discharge mode, number of cells, and the delay time
setup. If the parameters are correct, tap the START button for operation. The discharging
sequence is shown below.

LiPo, Lilon, LiFe, NiCd, NiMH battery discharge processes

Discharge mode per battery type

[ AUTOMATIC ]
- In this discharge mode, the discharge process proceeds automatically. The first two steps include
checking the number of cells and determining the discharge current. The charger then calculates the internal
resistance and discharge current for every period of time. The programming automatically adjusts the discharge
current to ensure that the optimal discharge current is delivered to your pack.
- Cutoff voltages (NiCd=0.9V/cell, NiMH=0.8V/cell, LiIon/Po=3.0V/cell, LiFe=2.5V/cell, Pb=1.8V/cell) are
applied (Charging the Lithium and Pb batteries after discharging does not affect the battery performances.)
- The preset CUT-TEMP is used in this discharge mode.
21
(1) Balancer port Test
After configuration, tap the battery
mark long and the balancer port
test will be performed. And then it
will be stand-by for start
This screen will be presented
if the balancer is not connect-
ed. And the Cell count could not
be changed by manual. Tap the
screen and it will be stand-by for
start.
(It will not be presented in case
of NiCd and NiMH)
(2) Discharge mode and Delay time
Discharge mode selection
Configure the Delay time for Discharge option and operation
start. The Discharge option could be picked tapping re-
peatedly. According to the batteries, the Discharge options
are following.
Press the
charge mode.
Delay time setup
It will be available from 1 to 150 min. This is a reserved
timer for starting the Charge mode.
button for starting the Dis-