Settings; Factory Settings - Sony MG10-P1 Manual

5. Settings

The settings described in this chapter concern the setting of the
parameters for initializing the main unit when the power is turned
on. The settings of the parameters which have been set are retained
even after the power has been turned off.

5-1. Factory Settings

Stored value settings
Settings are changed using the RS-232C setup command (see
section 5-4).
Item
Reference point
Measuring mode
Preset value
Comparator set number
Comparator upper limit
Comparator lower limit
Start/Hold function
RS-232C trigger input setting
RS-232C output data format
Unit
RS-232C data transfer format
MG10-P1 / MG10-P2
Factory setting
Not used
Current value mode
0
1
0 * For all set numbers 1 to 4
0 * For all set numbers 1 to 4
Start function
Low-speed mode setting
Measuring mode + Go/No
GO judgment result addition
mode (mode 3)
See section 6-1-3.
mm
Separation by spaces
Communication parameter settings
(RS-232C communication setting switch)
These settings are changed using the DIP switches. (See section 5-
2)
Communication speed : 9600 bps
Data length : 8 bits
Stop bit length : 1 bit
Parity : None
Delimiter output : " C R " + "
Flow control : Hardware flow control (RTS, CTS)
L F "
17
(E)