Table of Contents
Advertisement
7.7 Information on the operation of the stove
When entering menu 7, you can scroll through a few parameters on the display. The table below contains an
example of the values shown on the display together with their meaning.
Displayed status (example) meaning
3.1"
52'
Toff
106°
1490
7.8 Technical settings
IMPORTANT!
Menu 08 is reserved only for authorised service partners. Any change in the parameters that was made by
unauthorized persons will result in the loss of warranty!
When an error occurs, the Alarm LED turns on and the stove automatically stops working.
The respective
alarm will show on the display for a certain time followed be the buzzer (if activated). The alarm
can be cleared by pressing and holding button 3. Whenever an alarm is cleared, the stove automatically enters
the final cleaning phase and shuts down completely for safety reasons. The Alarm LED will remain on and the
buzzer (if activated) will sound intermittently during the entire alarm phase. If the alarm is not cleared by
pressing button 3, the stove will initiate the final cleaning phase and the alarm message will remain on the
display.
The table below shows all 8 potential errors. Every error is explained in detail below.
Cause
Power outage
Smoke temperature sensor failure
Overheating
Exhaust fan failure
Ignition failure
No pellets
Thermal safety overheating
No negative pressure
Auger/Pellet loading status
Max. time for ignition phase
Thermostat status
Smoke temperature
Exhaust fan speed
8. Potential errors
Display shows
AL 1 BLAC-OUT
AL 2 PROBE EXHAUST
AL 3 HOT EXHAUST
AL 4 FAN FAILURE
AL 5 NO LIGHTIN-
AL 6 NO PELLET
AL 7 SAFETY THERMAL
AL 8 FAILURE DEPRESS
17
Advertisement
Table of Contents
