Using The Stove; Turning The Stove On And Off - ADURO P2 Manual

6. Using the stove

Make sure the stove is connected to the power source and the chimney.

6.1 Turning the stove on and off

To turn on the stove, press and hold button 3. The ON/OFF LED starts flashing.
During the pre-heating phase, the igniter and the exhaust fan start to work, indicated by the respective LED
on the display. After approximately 1 minute, the auger starts to turn and transport pellets into the brazier.
Once the needed smoke temperature is reached, the stove enters the fire-on phase and the igniter turns off.
When the smoke temperature remains above the minimum for a certain period, the stove will enter the
normal work phase. This is indicated by the ON/OFF LED shining permanently.
Now, the heat level and the room temperature can be changed according to the instructions under section
6.2.
From time to time, the stove will clean the brazier by reducing the auger speed and increasing the exhaust
fan speed. The stove automatically returns to the normal work phase.
To turn off the stove, press and hold button 3. The ON/OFF LED starts flashing. The stove starts the final
cleaning phase, while the auger stops and the exhaust fan speed increases. After the final cleaning is
completed, the stove is turned off.
6.2 Temperature and heat level settings
The wanted room temperature can be changed by pressing button 1 followed by button 2 to increase or
button 1 to decrease the temperature. Press button 3 to exit or wait a few seconds for the set room
temperature to disappear from the display.
Once the set room temperature has been reached, the stove will automatically reduce the heat level to the
minimum (1). If the room temperature falls below the set value the stove will return to the previously set heat
level.
The heat level can be changed by pressing button 2 followed by button 2 to increase or button 1 to decrease
the level (1-5). Press button 3 to exit or wait a few seconds for the set heat level to disappear from the
display.
12