Transport and Packaging
Transport the appliance
Secure the appliance sufficiently and protect it
against weather during transport.
Unpacking the appliance
Remove the appliance from its packaging.
Remove all packaging material, such as foils, filler
and cardboard packaging.
To prevent hazards, check the appliance for any
transport damage.
In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
"Cleaning and Maintenance".
according to chapter
Appliance Equipment
Hob arrangement
NOTE:
The listed power settings can vary depending on the
material and/or size of the cookware.
1 Control panel
2 Ø20.0 cm / 1800 W
3 Ø16.5 cm / 1200 W
Delivery scope
Installation material:
4x mounting bracket, 4x fixing
screw
4
Ø20.0 cm / 1800 W
5
Ø16.5 cm / 1200 W
WARNING:
The installation and the connection to the main power
may only be performed by an authorized specialist.
CAUTION:
The worktop, the cabinet, veneers, plastic coatings,
used adhesives etc. must be sufficient heat-resistant.
NOTE: Recommendation!
When installing, ask another person to assist.
Wear protective gloves to avoid injuries at possi-
ble sharp edges.
Safety distances
CAUTION:
Make sure that adequate air circulations ensured,
and the ventilation slots are not blocked. Follow ap-
propriate safety distances!
The device must be installed so that heat can be
dissipated. The ventilation openings (D) and (E)
must not be blocked.
The distance between the hob and an extractor
hood must be at least as large as specified in the
instructions of the extractor hood!
There must be a minimum distance below the cut-
out. In this area are not allowed heat-sensitive ob-
jects (cabinet, drawer, etc.). Any existing side
walls or drawer boxes must be sawed out or re-
moved accordingly.
6
Installation
A 760 mm
B 50 mm
C 20 mm (min.)
D Air intake 35 mm
E Air outlet 5 mm