Programming Menu - Ultra Start 1150 Series Install Manual

REMOTE VEHICLE STARTER

Programming Menu

Turn the ignition key to the on position 3 times then press and release the program button. The park lights
will turn on and the horn(Optional) will honk once. While the park lights are on press and release the program
button until the LED is flashing the same number of times as the program setting that is to be changed.
Press and hold the program switch until the park lights flash the correct number of times as the option to be
programmed.
Setting 1- Special Door Lock/ Unlock Operations
1 Type 1
2 Type 2
3* Normal Operation
Press the Program Button 1 time to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program Button until you receive the appropriate # of park light flashes and
horn honks.
Release the Program Button . Press momentarily to move to next program step or repeat to
change selection.
Setting 2- Gas/ Diesel Mode- Blue Wire on 14-Pin
1 Negative Input/ 30seconds
2 Timed Delay/ 15 Seconds
3* Gas/ Positive Glow Plug
Press the Program Button 2 time to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and horn honks.
Release the Program Button . Press momentarily to move to next program step or repeat to change selection.
Setting 3- Rearm Output- Yellow Wire on 14-Pin
1 Type 1
2 Type 2
3* Factory Re-arm
Press the Program Button 3 times to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection.
Setting 4- Run Time
1 30 Min Run Time
2 45 Min Run Time
3* 15 Min Run Time
Press the Program Button 4 times to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection.
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
3 Flashes
1 Flash Pulse after start and with lock
2 Flashes Pulse after start only
3 Flashes 0.75 second pulse with lock and after shutdown
1 Flash Remote Starter runs for 30min when activated
2 Flashes Remote Starter runs for 45min when activated
3 Flashes Remote Starter runs for 15 min when activated
INSTALLATION MANUAL
Unlock before start. Lock pulse after start and shutdown
Lock pulse only after remote starter shuts off
No additional re-lock pulses
Waits a maximum 30 seconds before starting.
Ignition ON for 15 seconds before engaging remote starter
Waits 2 seconds to start if no diesel input is detected
Continued on next page.....
Page 7