Programming Overview; Entering Program Mode; System Reset - Ultra Start 1150 Series Install Manual

INSTALLATION MANUAL
Page 6

Programming Overview

Program mode allows you to adjust the settings and options of your system. Your system has been
intelligently designed by installers with years of experience. The system's default settings do not require any
program changes in most cases. However, this system does incorporate a highly advanced programming
system that can be easily adjusted for custom installations and applications.

Entering Program Mode

1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave in the "ON" position.
3) Press and release the Program Button.
4) The park lights will come on and the horn (optional) will honk to confirm Program Mode.
* Turning off the ignition or 30 seconds of no activity will exit the Program Mode. This will be
confirmed by 1 long horn honk and park light flash.
**: If the unit does not enter Program Mode, turn ignition off for 5 seconds and repeat steps 1-4. **
The first ignition(Blue)MUST be connected to the vehicle's first ignition wire. If it is not connected
It will not be possible to enter the Program Modes.
Changing the Programmable Settings
1) Enter Program Mode. (See Above)
2) Press & release the Program Button the correct number of times to select the desired
Program Setting. The LED's will flash and the horn (optional) will honk to indicate the current
setting that is selected.
4) Hold the Program Button until the parking lights /horn confirm the selected setting. The park
lights will flash and the horn (optional) will honk to indicate the option selected within the setting.
5) Turn the ignition key "Off" to exit Program Mode.

SYSTEM RESET

In some cases it may be necessary to reset the system to it's default settings. The system reset
will change all program settings to there default setting (Bold Text). A system reset must also be
preformed when the tach setting is to be re-learned.
1) Within 3 seconds turn the key ON-OFF-ON-OFF-ON (Leaving Key ON).
2) Press and release the Program Button.
3) The park lights will turn ON and the horn(Optional) will honk once.
4) Press the Program Button a second time and hold for 8 seconds.
The park lights will flash and the horn (Optional) will honk 3 times.
The System is now re-set to the factory default settings.
REMOTE VEHICLE STARTER