Ultra Start 1150 Series Install Manual page 8

INSTALLATION MANUAL
Page 8
See page 6 for Entering Program Mode.
Setting 5-Maximum Crank Time
1 10 Seconds
2 3 Seconds
3*5 seconds
Press the Program Button 5 times to select setting 5 (This will be confirmed by 5 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection.
Setting 6- Tach Selection
1Tach Detection Mode
*2Tachless Mode
Press the Program Button 6 times to select setting 6 (This will be confirmed by 6 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection
Setting 7- Adjust For Over-Crank
1 - Enter Program Mode (Ignition ON-OFF-ON-OFF-ON) then press the Program Button.
2 - Press the Program Button - 7 times (Led will start flashing 7 times).
3 - Hold the Program Button - For 5 seconds until parking lights flash (each time lights flash tach is reduced).
4 - Release the Button - Exit Program Mode and remote start to test.
Setting 8- Adjust For Under-Crank
1 - Enter Program Mode (Ignition ON-OFF-ON-OFF-ON) then press the Program Button.
2 - Press the Program Button - 8 times (Led will start flashing 8 times).
3 - Press and Hold Program - For 5 seconds until parking lights flash (each time lights flash tach is increased ).
4 - Release Program - Exit Program Mode then remote start to test.
Setting 9- Start Trigger Input- Number of pulses to activate Remote Starter
1 Pulse Once
*2Pulse Twice
Press the Program Button 9 times to select setting 9 (This will be confirmed by 9 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button. Press Program Button momentarily to move to next program step or repeat to
change selection
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
1 Flash One pulse required to activate the remote starter.
2 Flashes Two pulses required to activate the remote starter.
10 sec Max time that starter will stay engaged
3 sec Max time that starter will stay engaged
5 sec Max time that starter will stay engaged
Set for Tach Detection - Must Connect Tach Wire
No Tach connection required
REMOTE VEHICLE STARTER