Telemark Cryogenics 1200 Instruction Manual page 8

T Telemark Cryogenics Microprocessor Based Cr
WARNING
During ins nstallation there is the potential to be exposed
voltage co components (up to 400v ac), which may result
electrocuti ution.
WARNING
Units mus ust always be operated with a suitable ground/
Failure to c to comply may result in fatal electrocution. Nev
with or rem remove any ground/earth connection from insi
machine.
WARNING
Isolate sys ystem before connection. Ensure the connect
used is co compliant with local electrical requirements. C
within the e unit is tri-rated to CSA/UL/CE norms. There
three powe wer wires and one ground wire; there is no ne
Feed cable ble through gland and terminate at main syste
having firs irst removed the protective cover. Ground the
primary gr ground point.
WARNING
Failure to r to replace isolator cover exposes operators to
fatal electr ctrocution. It is essential this primary protecti
be in place ce before the system is energised.
WARNING
Always iso isolate the system through the main circuit bre
attaching t g the remote control. When in remote operatio
additional al care to prevent personal injury.
WARNING
Failure to l to leak test the system as a whole, may result i
catastroph phic release of refrigerant, which presents a v
risk from f frostbite and or asphyxiation. See emergenc
shutdown n procedures and material safety data sheet f
guidance. e.
WARNING
The r refrigeration
refriger gerants and polio-ester oil. These do not pr
health th risks, but it is essential that the follo
precau autions are followed:
a) A Always wear eye protection.
Always wear surgical type rubber or latex glo A
system contains
Page 8 of 63
Cryochillers
ed to high
ult in a fatal
d/earth line.
ever tamper
side of the
ction cable
. Cabling
re must be
neutral line.
tem isolator,
the UNIT at
to potentially
ction always
breaker before
tion take
lt in the
very high
ncy
t for
a mixed ed blend of
present acute
llowing basic
loves.
Revision ion 1.0.7 October 2018