Rear Turn Indicators; Idle Adjustment - Gilera SMT 50 Manual

Rear turn indicators (03_20)

To replace the turn indicator bulbs, loosen screw «C» from the transparent plastic.
The bulbs have a bayonet coupling, to remove them press gently and twist anticlock-
wise about 30° and, then, withdraw it.
03_20

Idle adjustment (03_21)

Carburettor
Trouble-free carburetion is the basis for a good engine performance. The carburettor
is regulated in factory to perform the best carburetion. Do not alter this adjustment.
Adjusting the idle speed
This operation must be made with warm engine, in neutral position and with no ac-
celeration.
Twist the adjustment screw at minimum towards the inside or outside until the engine
03_21
idle speed is set at a point in which the engine is about to stop, but functioning normally.
For any other carburettor adjustment, contact an Authorised Service Centre Piag-
gio-Gilera.
WARNING
IT IS CONVENIENT TO MAKE A CARBURETTOR CLEANING PERIODICALLY
WITH CLEAN PETROL AND PRESSURED AIR.
CAUTION
MAKE ALWAYS THE ENGINE IDLE SPEED ADJUSTMENT WITH A HOT ENGINE.
40