Front Light Group; Headlight Adjustment - Gilera SMT 50 Manual

Front light group (03_14, 03_15)

Loosen two of the four rubber retainers on the fork. Draw the front cowl to access to
the rear part. Remove protection «A» to access the bulb. The bulb has a bayonet
coupling, to remove it press gently and twist anticlockwise about 30° and then with-
draw it.

Headlight adjustment (03_16, 03_17)

Place the vehicle over on a horizontal floor in front of a white screen placed at a 10 m
distance, in a darkened area with the vehicle in perpendicular position to the screen.
03_14
Start the engine and pull the throttle to 1/3 of its stroke, and turn the headlamp on.
Select low-beam light, the maximum demarcation limit between the dark and the light
area, must result in a height inferior to a 8/10 height from the ground to the centre of
the headlight. The front headlight pointing must be done with screw «A». Before
pointing the headlight, check that the tyres are inflated at the indicated pressure.
CAUTION
LIGHT BEAMS HEIGHT MUST BE WITHIN THE LEGAL LIMITS OF THE COUNTRY
WHERE THE VEHICLE IS USED".
03_15
03_16
38