Table of Contents
Advertisement
9. Check that the surface of the
face plate is clean and attach
the abrasive disc after peeling off
the backing material. Take great
care to position it centrally.
10. Fit the drive cover using the self-
tapping screws.
Fit the work stop to the frame using
the M8 x 20 bolt and flat washer.
CHECKS BEFORE USE
As with all machinery, it is important to ensure that the various components are
properly secure and in good order before use.
The sander is designed so that when switched ON, both the belt AND the disc
will rotate. It is also important therefore, to ensure that the belt runs true on the
rollers, referred to as 'Tracking'. Although the necessary adjustments have
been carried out at the factory, it is nevertheless prudent to perform this
check when first setting up your machine in the event it has been disturbed
during transit.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
11
Advertisement
Table of Contents
