Passive / Active Locks #3-#3-#2; Passive / Active Arming #1-#2-#3 - Ultra Start 430 Series Install Manual

REMOTE VEHICLE SECURITY
Voltage / Door Pin Sensing
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
3 - The siren will respond with the following:
Passive / Active Locks
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
3 - The siren will respond with the following:
Passive / Active Arming
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
3 - The siren will respond with the following:
Car Jack Mode (CJ series ONLY)
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
3 - The siren will respond with the following:
Siren/ Horn Output (441 series ONLY)
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
3 - The siren will respond with the following:
Reset System
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
3 - The siren will respond with the following:
NOTE: Repeat sequence to change selection
#1 - #1 then #3
1 Chirp
2 Chirps
#3 - #3 then #2
1 Chirp
2 Chirps
#1 - #2 then #3
1 Chirp
2 Chirps
#2-#1 then #3
1 Chirp
2 Chirps
#3-#2 then #1
1 Chirp
2 Chirps
#3-#3 then #3
3 Chirps
Voltage Sensing- No Door Pin Connection Needed
Door Pin- Door Pin Connection Required
Active Locks
Passive Locks
Active Arming
Passive Arming
Inactive
Active
Siren
Horn
System Reset
INSTALL MANUAL
PAGE 9