Ignition Auto Locks - Ultra Start 430 Series Install Manual

Vehicle security systems

Hide thumbs Also See for 430 Series:

Owner's manual (8 pages)

Owner's manual (4 pages)

Install manual (12 pages)

Table Of Contents

Table of Contents

Enter Program Mode

Entering program mode is done by the following steps:

1) Make sure ignition is in the off position.

2) Turn the ignition key ON - OFF, leaving key in the OFF position.

3) Press and release the Valet button two times.

4) The siren will chirp one time to confirm entering program mode.

( If this does not happen, turn ignition off, wait five seconds and repeat steps 1-4).

Passive / Active Arming

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#1 - #2 then #3

3 - The siren will respond with the following:

Passive / Active Arming

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#3 - #3 then #2

3 - The siren will respond with the following:

Door Lock Timing

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#1 - #3 then #1

3 - The siren will respond with the following: