Ultra Start 430 Series Install Manual page 6

INSTALL MANUAL
PAGE 6
Recommended Installation Procedures
Installing the LED- Choose a location that will be highly visible when the
LED is installed. Most vehicles are equipped with knock out panels in the
dashboard, these panels are easily removable and can be easily replaced if
necessary. Once the location is picked, use drill bit and drill a hole through the
panel. Test fit the LED into the hole. Plug the Led into the Red connector on the
main module.
Installing the Program Button- Choose a location to mount the Program
Button. This location should be hidden and not visible from outside the vehicle.
Once the location of the switch is picked, use a 1/4" drill bit and drill a hole.
Remove the nut and push the Program Button through the hole. Replace the
nut and tighten until the switch is secure. Plug the Program Button into the
Blue connector of the main module.
Basic Install
Step 1 - Connect All Of the Following Wires
Black Ground Input
Yellow Ignition Input
Red Power Input
Brown (+) Siren Output
White (+) Park lights
Green* (-) Door Input
Purple* (+) Door Input
*Test for door pin type (+ or -) then connect the appropriate wire.
Step 2- Plug-In The Module
Step 3- Test And Adjust The Shock Sensor
Step 4- Test The System
Your Basic Install Is Complete!
System ground input.
Input from vehicles ignition wire.
Constant 12 Volt input.
Positive output for siren.
Positive park light output.
Negative door pin switch input.
Positive door pin switch input.
REMOTE VEHICLE SECURITY
(see page 3)