Table of Contents
Advertisement
2. Place the unit into the area where it will be installed.
Check the door, sides and top for a proper fit. Also test
the make sure the door opens and closes freely.
3. Remove grille and place mark on the floor at the front
of the unit. Also place a mark on the floor in the center
of the unit (Figure 27).
Figure 27
4. Remove the unit. Using a square, extend a centerline
20-1/4" toward the back wall (Figure 28). At the back
of the centerline, mark a line that measures 11-1/16" to
the left and right. This line services as the back edge for
the Anti-Tip brackets and its furthest points mark the
outer edge of each bracket.
Note: Instructions are shown for built-in installation. Use
same dimensions for free-standing installation.
Back
Wall
Front
of Unit
Marks
11 - 1/16"
on Floor
Figure 28
5. Place the Anti-Tip brackets on the floor against the line
drawn for the outer edge. Mark spots for the screw
holes (Figure 29).
6. Use a 1/8" drill to make two starter holes and fasten the
Anti-Tip brackets to the floor using the screws provided.
03/2008
2175BEV/2175BEVOL2 Beverage Center
Marks on floor
Line Marks
Back
of Unit
20 - 1/4"
11 - 1/16"
Centerline
Other hardware is required for floors made of
materials other than wood.
7. Place the unit back into position, making sure the feet
engage the Anti-Tip brackets properly. Check the
alignment of the lines made on the floor in step 3 with
the position of the front feet to ensure proper
positioning.
SINGLE UNIT INSTALLATION
1. Remove the two screws from the opposite side of the
hinge assembly using a Phillips screwdriver (Figure
30).
Right–handed units shown, Left–handed units are mirrored
2. Place bracket (part # 14154) over holes and attach to
unit with two screws removed in step 1 using a Phillips
screwdriver. Tighten screws fully.
3. Recheck the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.
4. Secure bracket into adjoining surface.
15
Drill Holes and
Mount Anti-Tip
Brackets to Floor
Back
Wall
Back
of Unit
Front
of Unit
Figure 29
CAUTION
Figure 30
www.U-LineService.com
Advertisement
Table of Contents
