U-Line 2075 User Manual page 20

User's Manual
TEMPERATURE CONTROLLER
The temperature controller (Figure 17) is located in the top
drawer. It consists of an LED display, two LED status indicator lights and
three touch pad buttons. The LED display shows the temperature set
point and is calibrated in degrees Fahrenheit. The controller is factory
programmed for a set point of 38°F which will show when the unit is first
powered-up.
To display actual temperature, press the "WARMER" button momentari-
ly. A solid status indicator light (1, Figure 17) will show the air tempera-
ture reading in the cabinet for approximately 10 seconds.
To adjust the temperature set point, press the "SET TEMP"
button momentarily; the display will flash. Press the "WARMER" or
"COOLER" button as desired to change the set point. When the desired
set point shows on the display, wait 10 seconds and the new set point
will be saved. Wait 24 hours for the temperature to stabilize before
checking the actual temperature again.
Refer to Table 1 to determine indicator light status.
LED Status
1 • Solid
• Flashing
2 • Flashing
1
WARMER WARMER
COOLER COOLER
Indicates
• Refrigerator Temperature displayed
• Not Applicable
• Open Thermistor – call for service
Table 1. Indicator Light Status
2
SET
TEMP TEMP
CLRCO011B
Figure 17
18