U-Line 2075 User Manual

Drawer refrigerators

Hide thumbs Also See for 2075:

Supplementary manual (1 page)

Supplementary manual (10 pages)

Supplementary manual (6 pages)

Table Of Contents

É c h e l o n

™

Table of Contents

Summary of Contents for U-Line 2075

Page 1 É c h e l o n ™...
Page 2 (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Line’s...
Page 3: Introduction
Congratulations on your purchase of the U-Line 2075DWRR drawer unit. A pioneer in the field for more than 40 years, U-Line is the world’s number one manufacturer of built-in, under-counter ice making and spe- cialty refrigeration products. U-Line dedicates 100% of its research and development to these products.
Page 4: Table Of Contents
User’s Manual If you do not return your Product Registration Card, U-Line will use the date of sale to the U-Line distributor as the first date of warranty for your unit. Please also record the purchase date of your U- Line unit and your dealer’s name, address and telephone number.
Page 5: Safety Precautions
SAFETY PRECAUTIONS Do not attempt to install or operate your unit until you have read the safe- ty precautions in this manual. Safety items throughout this manual are labeled with a Danger, Warning or Caution based on the risk type. DEFINITIONS Danger means that failure to follow this safety statement may result in severe personal injury or death.
Page 6 • Never install the unit behind closed doors. Be sure front grille is free of obstruction. Obstructing free air flow can cause the unit to malfunction, and may void the warranty. • Use only genuine U-Line replacement parts. Imitation parts can damage the unit, and may void the warranty. DANGER...
Page 7: Installation
SITE PREPARATION Your U-Line drawer unit must be installed under a counter or in a wall. The unit is designed so it can be installed next to a wall, because the crisper can be accessed from either side. 1. Position the unit on a flat, level surface, capable of supporting the entire weight of the unit.
Page 8 User’s Manual Your U-Line Drawer unit is designed so it can be installed next to the wall on either side because the crisper can be accessed from either side (Figure 1, 2). Figure 1 – Right wall installation The anti-tip kit must be installed on this unit before it is used.
Page 9 CABINET OR WALL DWR002 Figure 2 – Left wall installation 24" MIN. DWR003 Figure 3 – Front Clearance...
Page 10: Leveling The Unit
User’s Manual 4. Position the unit to allow free air flow through the front grille (Figure 4). LEVELING THE UNIT It is important that the unit is level. All Échelon™ Series units are equipped with adjustable feet for leveling and height adjustment (Figure 5).
Page 11 4. Place the unit in position where it is to be installed. Re-check cabi- net height and levelness (Figure 6) and adjust if necessary. RAISE LEVEL TWO PLACES LOWER Figure 5 Figure 6 DWR005 DWR021...
Page 12: Built-In Installation
User’s Manual BUILT-IN INSTALLATION Your U-Line product is designed for built-in installation only. When built-in, it does not require additional air space for the top, sides, or rear. However, the front grille must NOT be obstructed. To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least 1/4"...
Page 13: Custom Drawer Panels
ANTI-TIP KIT CUSTOM DRAWER PANELS Two types of custom drawer panels can be installed on your U-Line unit to harmonize with or accent the surrounding decor. FULL OVERLAY DRAWER PANEL Full overlay drawer panels completely cover the drawer frames and han- dle to give a built-in appearance.
Page 14 User’s Manual OVERLAY PANEL KIT PARTS Part Number Description 42120 Spacer Nylon 3/8 OD x .19 ID 42121 Screw #10 x 5/8 Round Head • The total weight of both drawer panels must not weigh more than 20 lbs. • The thickness of the drawer panel must be 3/4". Remove existing drawer front from cabinet: 1.
Page 15 5. On a clean surface, place the wood panel face down and tape the existing drawer panel (removed in step 3) on the back of the wood panel (Figure 10) and drill the five (5) holes (5/32" drill 3/8" deep) through the coated steel panel and 3/8"...
Page 16 User’s Manual 6. Attach the drawer panel to the wood panel using #10 x 5/8" (P/N 42121) wood screws and nylon spacers (P/N 42120). The nylon spacers fit between the wood panel and the drawer panel as shown (Figure 12). TYPICAL WOOD PANEL...
Page 17 (examples are: custom 1/4 inch panel inserts, or no panel at all - standard black finish), replacement drawer handles MUST be installed on each drawer. The part number is 11926-4-BLK and can be purchased from your U-Line dealer. DWR007 Figure 13...
Page 18 User’s Manual Install the custom insert as follows: Insert edges may be SHARP! Use care when installing. 1. Open drawer. Pull drawer gas- ket out of groove (top edge of drawer only). Start in the mid- dle and pull outward, moving toward the edge (Figure 14).
Page 19: Initial Start-Up And Adjusting The Temperature Control
5. Slide custom drawer panel insert into 1/4" channel in drawer front. 6. Attach the full handle to the lower handle using the 3 screws removed in step 2. 7. Holding drawer gasket out of the way, replace handle on drawer making sure it is seated properly on insert and that screw holes line 8.
Page 20 User’s Manual TEMPERATURE CONTROLLER WARMER WARMER COOLER COOLER The temperature controller (Figure 17) is located in the top drawer. It consists of an LED display, two LED status indicator lights and three touch pad buttons. The LED display shows the temperature set point and is calibrated in degrees Fahrenheit.
Page 21 DRAWERS The drawers should only be removed for servicing by a trained and certified repair person. TOP STORAGE BIN Grasp the bin handle and slide back- ward to access the contents below (Figure 18). The bin may be completely removed for cleaning once it clears the guides on each side of the drawer.
Page 22: Operation
User’s Manual OPERATION DRAWER ORGANIZER Adjust the drawer organizer to compensate for different size bottles or items. The organizer can be used in either drawer, but is shipped from the factory in the top drawer. The organizer may be adjusted left-to-right or front-to-back as required.
Page 23 Be sure that items stored in the rear STORAGE BIN of the top drawer do not interfere with the sliding operation of the stor- age bin (Figure 21). Tall items such as milk jugs can be stored toward the front of the drawer as long as they do not interfere with the closing of the drawer.
Page 24 (Figure 22). 2. Replace bulb with genuine U-Line #31317 replacement. U-Line P/N 31317 Do not use any other replacement bulb than the one recom- mended.
Page 25: Cleaning & Maintenance
CLEANING & MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency, top per- formance, and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets, the unit is used outdoors, or other special considerations. EXTERIOR CLEANING —...
Page 26 User’s Manual 5. Reconnect power to the unit. • DO NOT use solvent cleaning agents or abrasives on the interior. These cleansers may damage or discolor the interior. CONDENSER CLEANING - EVERY 3 MONTHS Disconnect electric power to the unit before cleaning the condenser.
Page 27: Storage
DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. 3. Clean the condenser coil using a soft brush with a “combing” action or vacuum cleaner. Do not touch the condenser coil. 4. Position the grille to align the screw holes with the cabinet. 5.
Page 28: Troubleshooting
User’s Manual TROUBLESHOOTING BEFORE CALLING FOR SERVICE If the unit appears to be malfunctioning, read through NORMAL OPERA- TION first. If the problem persists, check the TROUBLESHOOTING GUIDE. Locate the problem in the guide and refer to the cause and its remedy before calling for service.
Page 29: If Service Is Required
REPLACEMENT PARTS Use only genuine U-Line replacement parts. Genuine U-Line parts are designed to work correctly with U-Line products and offer superior service life. The use of non-U-Line parts can damage the unit and may void the warranty. Possible Cause Temperature not set cold enough.
Page 30 User’s Manual...
Page 31 P . O . B o x 2 4 5 0 4 0 Milwaukee, WI 53224-9540 P h o n e : 4 1 4 . 3 5 4 . 0 3 0 0 F a x : 4 1 4 . 3 5 4 . 7 9 0 5 w w w .

U-Line 2075 User Manual

Table of Contents

Related Manuals for U-Line 2075

Summary of Contents for U-Line 2075

Table of Contents