4. Locate the compression fit-
ting and ferrule packed in the
unit. Slide the compression
fitting and ferrule over the
1/4 inch water supply line.
Do not use thread sealing
compound or tape.
two wrenches, tighten the
compression fitting on the
supply line (see Figure 6).
Figure 6
5. Carefully bend the water sup-
ply line into position and con-
nect the line to the solenoid
valve (see Figures 7 and 8).
Avoid kinking the water sup-
ply line.
Figure 7
Using
UL134
POWER
CORD
WATER LINE
UL201
WATER LINE
6. For recessed installations,
allow extra water supply line
length to provide slack for
easy
removal
recessed area (see Figure
9). This will also safeguard
against kinking the line.
11
Figure 8
from
Figure 9
UL204A
the
UL200