Control Handle For Bike Handle; Removal And Installation - Stihl FS 240 Service Manual

1
2
: The torsion spring (1) must be
seated in the mount (2)
1
2
3
: Check installation position of
torsion spring (2) and slide
control (1)
– see illustration
For the throttle trigger to be seated
correctly, the torsion spring (2) must
be pushed onto the post (3) over the
ribbed base
– Torsion spring is completely inside
the handle molding.
Checking operation
– Set slide control to position
STOP-0 , the contact spring must
actuate the microswitch – this
can be heard as a clicking noise
– Install throttle trigger / throttle
trigger interlock, b 10.1.1
– Check throttle cable setting,
adjust if necessary, b 10.2.4
– Reassemble remaining parts in
reverse order
FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
10.2 Control handle for bike
handle
1
The control handle for bike
handle (1) with lever for stop
function (arrow) is pushed directly
onto the bike handle (diameter
25.4 mm or 22 mm) and secured
with a transverse screw.

10.2.1 Removal and installation

1 1
3
: Unscrew and remove the
screw (1), remove nut on the
opposite side
: Remove control handle (2) from
bike handle (3)
1-point antivibration system
: Remove protective tube (1) from
the guide (arrow)
4-point antivibration system
2
2
: Remove screw (1), push
fairing (2) toward engine and
remove
: Remove protective tube (1) from
the guide (arrows)
– Examine throttle cable or short
circuit wire and replace if
necessary, b 6.6
– Examine actuating lever, replace
if necessary, b 10.2
1
1
1
85