Table of Contents
Advertisement
Operating
DMX address, DMX mode
ACL LED Par 64
32
LED PAR
1.
Press [Mode] and use [Up] or [Down] to select the menu item 'DMX' . Confirm with
[Setup].
2.
Use [Up] or [Down] to select a value between 'Address 001' and 'Address 512' to set the
DMX address.
3.
Press [Setup] to accept the selection.
4.
Use [Up] or [Down] to select the desired DMX mode (1 or 2 channels). Depending on the
selected mode, the display shows '1-CH' or '2-CH' .
5.
Press [Setup] to accept the selection.
This setting is only relevant when the device is controlled via DMX. Make sure that this number
matches the configuration of your DMX controller. The following table shows the highest pos‐
sible DMX address for the various DMX modes.
Advertisement
Table of Contents
