Wall Mounting - Verizon TR1V1 User Manual

2.2

Wall Mounting

Note: The Extender can only be mounted on drywall or wooden walls.
1. Find a location on the wall near where the installation location label is placed. Peel off the
protective backing on the Gecko Tape on the back of the mounting bracket, and remove the cover
on top of the bracket base. Afterwards, place the mounting bracket against the wall at the
aforementioned location using the same alignment used for window installation.
2. Use a pencil to mark the points on the wall directly under the center of the two mounting holes of
the mounting bracket.
3. For installation on drywall, after completing the steps in item 2, move the bracket off the wall. Use
a power tool to drill pilot holes at the marked points (Note: the diameter of the pilot holes must be
smaller than the diameter of the included wall anchors), then push the anchors into the pilot holes
until they are flush to the wall. Afterwards, align the center of the two mounting holes of the
mounting bracket with the anchors, then use a screwdriver to slowly screw the included metal wall
screws into the anchors until the bracket is securely fastened.
9