2.2
Combining the Power Units and Bypass Unit
1. Remove the left and right side panels from the input and output unit.
2. Combine the power units, bypass unit and input/output units, and install the connecting plates in
the following sequence: bottom, top, and middle.
3. Install the side panels removed from the input and output unit to power unit 1 and power unit 3.
4. Secure the UPS.
(A) Mounting holes on the channel steel: M12x60 bolts
(B) Mounting holes on the floor: M12x60 expansion bolts
Channel steel or bolts are not included.
3