Instruction Sheet
VIQUA Water Filters Installation
Section 1
Safety Information
Please read this entire instruction sheet before operating this equipment. Pay attention to all danger, warning, and caution
statements in this instruction sheet. Failure to do so could result in serious personal injury or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this equipment in any manner
other than that specified in the instruction sheet.
1.1 Safety Precautions
If water pipes are used to ground electrical system, appliances, or phone, install a jumper wire.
Read and understand this Instruction Sheet before operating and performing any maintenance on this equipment.
Warning: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Section 2
Installation
•
DO NOT install on line pressures above 100 psi (6.9 bar).
•
DO NOT overtighten pipe fittings.
•
DO NOT use wicking or sealer, Teflon
•
DO NOT use torch near plastic housing. All sweated joints should be made prior to assembling piping to the filter head.
•
Replace O-ring seal, if there is visible damage.
•
Maximum temperature allowed is 38 °C (100 °F). Special hot water filters are available for higher temperatures.
•
Protect the filters from freezing temperatures.
•
DO NOT install in direct sunlight.
•
Allow minimum of 2" clear space under filter to facilitate cartridge change.
•
DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
C A U T I O N
N O T I C E
WA R N I N G
™
tape is recommended.
AWP40B-V, AWP42B-V, AWP50B-V
and AWP52B-V are Tested and
Certified by NSF International against
NSF/ANSI standard 42 for material
and structural integrity requirements.
COMPONENT
520094_RevF
Need help?
Do you have a question about the AWP40B-V and is the answer not in the manual?
Questions and answers