Se-Kure Controls Vantage II Instructions

Vantage II Alarm Instructions
2. Pull the Battery Holder Tab
from inside of the stand (you
will find it lodged in the tube
after the top has been
removed).
NOTE: the LED Light on the stand will blink yellow. This only indicates that
the Vantage Alarm has power but has not been programmed.
Mounting
Instructions:
Install the
Vantage Alarm Base
Battery Installation:
SKP-200K Security Wrench
SKP-190 TPS Security Bit
3. Install (3) three new Alkaline
AAA Batteries making sure to
follow the (-) negative and (+)
positive polarity markings on
the battery holder.
1. Remove the (2) two security
screws around the base of
the stand with a SKP-190
TPS Security Bit. (Save these
screws for reinstallation).
1. Remove the (2) two security
screws at the top of the stand
with the SKP-200K Security
Wrench. (Save these screws
for reinstallation).
4. Insert the Battery holder into
the display stand tube and
replace the top. Replace and
tighten the screws.
2. Lift the stand off from the
base plate.
Page 1