Advertisement
ECU configuration for Elite Series ECUs
1. Connect to the ECU with the ESP software
(Elite Software Programmer)
2. Go into "Main Setup" (press F4)
3. Click "Devices" on the left tab
4. Under Haltech CAN System, enable the
Haltech CAN Supported Dash (see below)
5. For extended functionality of the IC-7 Display
Dash, Elite firmware 2.35 or later is required.
Earlier firmware versions are supported, but
some channels may not display.
CAN Connection: DTM-4 receptacle
Pin Number
1
2
3
4
CAN Connection: 34 pin Superseal Connector
Pin Number
1
2
3
4
Connecting IC-7 Display Dash to a Haltech Platinum Series ECU:
You will need to use an 8-pin Tyco to DTM-4 cable to connect all Platinum Series ECUs to
this device. This cable is supplied with the ECU.
If you already have a Platinum Series ECU and are adding the IC-7 display dash to your
system this cable can be purchased separately (HT-130040).
11
Connection
+12V Supply
Battery Ground
CAN High
CAN Low
Connection
CAN High
CAN Low
+12V Supply
Battery Ground
Rear View, Wire Side
Rear View, Wire Side
Advertisement
