Led Signals - Weidmuller Transclinic 16i+ User Manual

WARNING
This product can only be serviced by Weidmüller. Failure to observe this
requirement voids the warranty and can lead to dangerous situations.
Please contact your Weidmüller sales representative for service information.

5.1 LED signals

The Transclinic 16i+ is equipped with two signal LEDs which indicate the system's
status without use of further equipment.
The green LED provides information about the supply voltage and RS-485 activity.
The red LED provides information about fault states.
LED signals table
Colour Status
Green Fix
Blinking
Off
Red Blinking
Fast Blinking
Off
76
Description
the product is supplied with voltage and can operate
It exists RS-485 activity (transmitting and receiving)
The product is not supplied (with 24 V)
An incident is present (i.e. blown fuse)
Internal error (i.e. supply voltage too low)
No fault / user defined alarm is present