Table of Contents
Advertisement
Available languages
Available languages
3.6 DIP switch configuration
Use the DIP switches to configure the Modbus device address (SW 1) and the RS–485
serial settings (SW 2).
model of Transclinic device
SW1 – The following table specifies the binary coding of the Modbus device address
via DIP switches. The factory default slave address is 1 (i.e. SW 1.1 in the 'on' position
and SW 1.2 to SW 1.8 in the 'off' position). As an example the DIP switch coding for
Modbus address 175 is shown (10101111 in binary).
SW 1.1
Weight
2
(LSB)
0
Address
increment
Example address 175
ON
To change ID number, baudrate or parity the process must be as it follows:
• configure the desired ID, baud rate or parity.
• Set the SW2.2 in ON position
• Switch-on the device
• Change the SW2.2 from ON to OFF
• Switch-off the device and wait 5 seconds (any LED might be ON)
• Switch-on again the device
The photo shows the factory default settings depending on the
SW 1.2
SW 1.3
2
2
1
2
1
2
4
ON
ON
SW 1.4
SW 1.5
SW 1.6
2
2
2
3
4
5
8
16
32
ON
OFF
ON
SW 1.7
SW 1.8
2
2
(MSB)
6
7
64
128
OFF
ON
71
Hide quick links:
Advertisement
Chapters
Table of Contents
