Troubleshooting - Russell Hobbs RHPAC3001 Manual

PROBLEM
The appliance does not come
on
The appliance works for a
short time only
The appliance works but does
not cool the room
During operation, there is an
unpleasant smell in the room
The appliance does not
operate for about three
minutes after restarting it
The following message
appears on the display:
LT/PF/FT

TROUBLESHOOTING

-There is no current
-It is not plugged into the
mains
-The internal safety device has
tripped
-There are bends in the air
exhaust hose
-Something is preventing the
air from being discharged
-Windows, doors and/or
curtains are open
-There are heat sources in the
room (oven, hairdryer etc.)
-The air exhaust hose is
detached from the appliance
-The technical specification of
the appliance is not adequate
for the room in which it is
located
-The air filter in clogged
-The internal compressor
safety device prevents the
appliance from being
restarted until three minutes
have elapsed since it was last
turned off
-The appliance has a self-
diagnosis system to identify a
number of malfunctions
CAUSE
Page 26
SOLUTION
-Wait
-Plug it into the mains
-Wait 30 minutes and if the
problem persists please
contact our Customer Service
team on 0345 209 7461.
-Position the air exhaust
correctly, keeping it as short
and free of curves as possible.
-Check and remove and
obstacles obstructing the air
discharge.
-Close doors, windows and
curtains, bearing in mind the
"tips for correct use" given
above
-Remove the heat sources
-Fit the air exhaust in the
housing at the back of the
appliance
-Clean the filter as described
earlier within this instruction
booklet
-Wait, this delay is part of the
normal operation of the
appliance
-See the SELF-DIAGNOSIS
section of this booklet