a. Mark the location of the bracket screw for the Safety Switch, and optionally the
two additional bracket holes.
b. Remove the inverter from the wall/ pole.
c. Drill the hole for the Safety Switch bracket.
d. Hang the inverter on the mounted brackets.
e. Fasten the Safety Switch bracket using a standard bolt.
7. Insert the screws at the top of the inverter brackets and fasten the brackets together.
8. Verify that all the brackets are firmly attached to the mounting surface.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.3
Figure 18: Safety Switch bracket
Chapter 3: Installing the Inverter
35