Installation Procedure; Installation Equipment List - SolarEdge SE3000H-US Installation Manual

Figure 3: 208V AC grids supported by SolarEdge single phase inverter

Installation Procedure

The following is the procedure for installing and setting up a new SolarEdge site. Many
of these also apply to modification of an existing site.
1. Connecting Power Optimizers in
2. Recording power optimizer serial numbers
3. Mounting the inverter,
4. Connecting the AC and the String to the DC Safety
Commissioning and activating the
5.
6. Connecting the inverter to the monitoring

Installation Equipment List

Standard tools can be used during the installation of the SolarEdge system. The
following is a recommendation of the equipment needed for installation:
Allen screwdriver for 4 mm screw type for the inverter cover, side screws, and Safety
Switch cover
Standard flat-head screwdrivers set
Non-contact voltage detector
Cordless drill (with a torque clutch) or screwdriver and bits suitable for the surface
on which the inverter and optimizers will be installed and for opening the Safety
Switch drill guides. Use of an impact driver is not allowed.
(1) 208V AC grids are only supported by some inverter models. Refer to the specification supplied with the
inverter.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.3
Chapter 1: Introducing the SolarEdge Power Harvesting System
Strings, page 23
Page 32
installation, page 40
(optional), page 44
Unit, page 36
platform, page 45
13
(1)