Installation - TEXA TMD MK3 SOS Installation Manual

6.3 Installation

The additional Y-shaped cable (code 3904674) is needed for the installation.
Install the TMD MK3 ACTUATOR LOCK inside the engine
compartment and away from heat sources.
The TMD MK3 ACTUATOR LOCK central unit must be easy to reach
in case of an emergency deactivation.
The system relay has a maximum range of 10 A.
1. TMD MK3 EDR
2. Y-shaped cable
3. TMD MK3 ACTUATOR LOCK
Proceed as follows:
1. Secure TMD MK3 ACTUATOR LOCK in the most appropriate position*.
2. Connect the two TMD MK3 ACTUATOR LOCK cables to the device that must be
inhibited.
3. Connect the cable with the TMD MK3 ACTUATOR LOCK connector to the Y-
shaped cable.
4. Insert the connector of the Y-shaped cable into the L1 input of TMD MK3 EDR.
(*) See the specific installation sheet for the vehicle you are working on.
24