Schwinn MPower Echelon2 Console Installation Manual page 9

If installing the Power sensor (740-8730), skip to Page
14, Step 1. Otherwise, continue to Step 4.
4. Plug the console cable (740-8928 "RJ45 2-PIN LONG CABLE)
RJ45 connector into the console then slide the grommet of
the cable into the slot on the connector protective cap as
shown.
5. Attach the protective cap to the bracket using the two M3 x
12mm socket head cap screws, and tighten with the 2.5mm
hex key
6. Prior to installing the upper conduit, clean head tube with
isopropyl alcohol and allow to air dry.
Page 9